FAA official signed off on Arkansas router work before ground stop

An FAA official oversaw and approved replacement of a router and copper wires with fiber-optic cables in Arkansas, the Washington Post reported. The work was completed eight minutes before Friday’s nationwide ground stop, complicating Transportation Secretary Sean Duffy’s criticism of contractor L3Harris Technologies.

Today, 11:41
170 0
FAA official signed off on Arkansas router work before ground stop

The upgrades were part of a national FAA effort to modernize communications infrastructure used by the airline industry. The Post reported that the official tested the Arkansas work before signing off on it.

Duffy said Saturday that the agency was investigating whether “incompetence” by L3Harris, which handled the Arkansas wire replacement and is leading the FAA’s fiber-optic upgrades, caused the 4.5-hour ground stop. He also said the replaced router was faulty and flooded the network with over 1,000 connection attempts every few seconds, overwhelming it and disrupting communication between aircraft and air traffic controllers.

The precise cause of the communications outage has not been confirmed, an anonymous source told the Post. Asked for comment by the newspaper, the FAA referred to Duffy’s remarks at a Tuesday news conference at the Capitol. There, he said he wanted L3Harris to “hire better minds” for the work and was considering bringing in other contractors.

FAA and L3Harris officials are studying the Arkansas device, which the Post identified as a Juniper router. L3Harris has stopped installing that model, though dozens are already in service, the newspaper reported.

Share

Comments (0)

Leave a comment

No comments yet. Be the first!